This post consists of all the assembly processes of all the necessary in-fuselage components to connect the rudder cables to the rudder pedals and the
As I wait to get access to the local EAA Chapter 67 Paint Booth, a friend suggested I make sure the rudder pedals and control stick were prep'd for
For me, working with aluminum is very challenging. The material, although it's flexible, it's not very forgiving. Meaning, the holes you drill must
Because of the accurate layout of the bottom boot cowl, this project was straight-forward. Everything lined up properly. The stiffener installation
I was expecting this project to be fairly simple until I learned that the pilot holes were not aligned properly with the frame engine mount holes.
Like the rotisserie for the wings I did not following the plans exactly. I used several "L" brackets at the bottom to make sure the connections were
This project was fairly simple as a result of mistakes I made with the forward baggage compartment. When I installed the forward baggage compartment
This was a fairly simple project. The tank mount needed to be paced off-center of the fuselage rib locations just enough to allow the gas sump to fit