Bottom Boot Cowl

by | Jun 28, 2020 | Rans S20 Build, Rans S20 Fuselage

Because of the accurate layout of the bottom boot cowl, this project was straight-forward. Everything lined up properly. The stiffener installation was also simple. However, one question that did surfaced is related to how far back the aft edge of the bottom cowl should be installed. Mine goes back further than the manual calls for. Aside from cutting out to accommodate the gear leg panel, I decided to leave it as is.

Time Spent- Sanding: 28 hours, 30 minutes

8 + 6 =

Content Protected Using Blog Protector By: PcDrome.
Verified by MonsterInsights