Horizontal Stabilizers

by | Nov 17, 2019 | Rans S20 Build, Rans S20 Fabric

I originally thought covering would go fairly quickly, but once again, it’s a brand new skill to learn by trial and error – mostly error!

Based on several other build sites for the S20, I decided to begin with the horizontal stabilizers . Below are a number of steps I took and results:

  • I cut out two pieces of fabric for each stabilizer with about 3 inches of excess around.
  • Using the 3M Fastbond 30nf glue, I brushed around the perimeter of the stabilizer – probably 60% around each tube.
  • After the glue had tacked appropriately, I pressed the fabric on the tubes with my fingers to hold the fabric in place.
  • I then used the small iron to do a light glue around the outside edge of the tube.

15 + 12 =

Content Protected Using Blog Protector By: PcDrome.
Verified by MonsterInsights