The patches are relatively easy to install but sometimes challenging to cut accurately. I typically would use an Xacto knife to cut accurate but small holes. In some cases, I had to make multiple cuts before I was satisfied. Some of the alignment on both patches and especially long tapes required a lot of time to line up accurately.
Wing Strut Mount Patch Gas Sump Drain and Brake Lines Door Patches This template was used to cut the patch around the tail section Wheel Strut and Water Drain Patches Patch across top of Window Overlay door patch. Below the door patches Overlay door patch
Time Spent- Sanding: 28 hours, 30 minutes