Well, it’s been several weeks since my last post. Although I have been spending a lot of time trying to figure a few things out on the Dynon system. According to the Rans manual the static port and Pitot tube are part of the same assembly on the front of the left wing. However, as a result of my decision to use the Dynon system, I decided to not install that pitot tube along side of the Dynon pitot tube but install in on the fuselage.

The learning process continues to push me in new areas. Today, I spent roughly 4 hours trying to bend the attachment tubes behind the Dynon pitot so that it will fit into the tabs I fabricated for each spar as shown below:

Content Protected Using Blog Protector By: PcDrome.