02/23/19 – Rib #8 reinforcement – Chase drilled four #40 holes to #30 through the support tab on the bottom of the bell-crank support casing and then riveted Rib #8. 2 hours
02/23/19 – Prepared tip ribs by drilling holes for the rivets for the rear spar. Drilled four holes on each of the bow tips for mounting of the tip ribs. 2 hours.
02/20/19 – Cleaned and prepared right wing ribs using fluting pliers to straighten – as much as possible. 2 hours
02/17/19 – Painted tip rib clips in preparation for install. 2 hours.
02/16/19 – Mounted Rib Clips onto spars and riveted most of the ribs. Holding on Rib #1 & #2 to make sure gas tanks fit properly first. 4 hours